How to Install and Clean Led Plant Lights?

Although the performance of LED plant lights can be described as strong compared to traditional plant grow lights, there are still many places that deserve our high attention in order to extend the service life of LED plant lights and to ensure their use, mainly the following points.

LED plant light installation

Whether it is the initial installation or repeated installation, it should be completed step by step according to the installation steps above in the lamp operation manual, and the installation conditions for using different types of LED plant lamps should be selected, such as: lamp link mode, series or parallel connection, and how many sets of lamps should be connected, etc; The voltage should be controlled around the normal voltage of the LED plant lamp. The difference should not be too large or too small. If the voltage is too large or too small, the lamp will be burned directly. If the voltage does not meet the use standard of the LED plant lamp, the effect of plant lighting is not obvious. A long time of low voltage is equivalent to a long time of starvation of the LED plant lamp chip. Anything hungry for a long time will get sick.

LED plant light cleaning

Any electrical equipment is the same. There will always be a lot of dust after a long time. The LED plant lamp needs to be cleaned externally and internally regularly. External cleaning is to clean the exterior of the lamp to ensure a clean and tidy appearance, and the crops planted will make people feel clean and sanitary; For the cleaning of light transmitting housing, LED plant lamp should keep working efficiently for a long time. In addition to the effect of LED plant lamp chip itself, the light transmitting effect of the housing panel is also very important. If the light transmitting housing is too seriously aged, its housing can be replaced directly, without affecting the normal use of the plant lamp.

The interior of the plant lamp is clean. Cleaning the interior of LED plant lamp is mainly to ensure the normal heat dissipation of the plant lamp, so as to avoid excessive accumulation, poor ventilation and reduced heat dissipation efficiency. When cleaning the interior of the LED plant, do not use a wet towel to wipe it to avoid corrosion of related metal parts. You can use a hair dryer to blow cold air or a soft bristle brush to gently remove the dust. To ensure the normal use effect of LED plant lamp and prolong the service life of the lamp.

Environmental control

The service environment of LED plant lamp determines its service life to some extent. The air humidity, LED plant lights are generally better placed in the dry place as far as possible, the internal components are not easy to be corroded, and will not produce too much fog to affect the light filling effect. Whether it is ventilated or not, it is more conducive to the heat dissipation of LED plant lamp under the condition of ventilation.